Ball Screw Translation Stage: Sub-Micron Laser Jig Alignment | Yangning

Nov 17, 2026

Leave a message

Shroud-protected Ball Screw Linear Actuator
Motorized Ball Screw Translation Stages: Sub-Micron Multi-Axis Alignment for Laser Etching Jigs
  • A motorized ball screw translation stage converts rotary servo motion into linear positioning via preloaded anti-backlash ball screw assemblies, designed to fix micro-positioning drift during laser etching of miniature electronic terminals. This unit delivers repeatability down to ±0.005 mm and suppresses Abbe angular deviation on XY stacked axes, eliminating jig misalignment caused by guideway pitch and yaw error.
  • High-magnification laser etching heads require jig positioning error below 2 μm. Two core mechanical errors dominate yield loss: first, axial backlash from un-preloaded ball screws; second, angular tilt of the carriage that generates Abbe error proportional to the offset between laser focal point and stage mounting surfaceParker Han...

 

Parameter Cross-Roller Guide (CRG) Recirculating Ball Guide (RBG)
Repeatability ±0.003~0.005 mm ±0.008~0.012 mm
Angular Stiffness (Moment Load) High (Line Contact) Low (Point Contact)Dover Moti...
Pitch/Yaw Error ≤8 arcsec ≥18 arcsec
Max Continuous Velocity 120 mm/s 350 mm/s
Maintenance Interval 12,000 hours 18,000 hours
Relative Capex 1.6x 1.0x

Download Detailed 3D CAD (.STEP) Models for high-rigidity double carriage ball screw linear translation slide table to calculate axis stack-up tolerance before mechanical design.

Hermetically-sealed Ball Screw Motion Stage

Send Inquiry