The quality of routine maintenance directly affects the lifespan of the dispensing machine. Daily maintenance significantly impacts the machine's lifespan and smooth operation. Below are the routine maintenance steps for dispensing machines:
1. When changing adhesive types, the pipeline needs cleaning. First, close the feed valve and open the discharge valve to drain the remaining adhesive from the glue tank. Then, close the discharge valve and open the feed valve to pour the cleaning solvent into the glue storage tank. Activate the machine and flush out the solvent as usual.
2. If the air pressure is abnormal or moisture is detected, remove the moisture from the pressure filter or check the air pressure source for any abnormalities. Before using the glue in large quantities, please conduct a small-scale trial to master the usage techniques and avoid errors. Once the test is successful, then proceed with mass production using a two-component dispensing or potting machine. Use a vacuum system to remove air bubbles generated during mixing, or let the glue stand for 10-20 minutes before use to allow any air bubbles to dissipate. The more glue mixed, the faster the reaction and curing speed.
3. Regularly clean the machine to extend its lifespan. The more glue mixed, the faster the reaction and curing. Therefore, mix the glue appropriately according to actual production needs to avoid waste. Prevent unexpected problems and improve production efficiency. Liquid control technology and dispensing equipment are now widely used in various production fields in modern industry.
4. When the machine is not in use for extended periods, unplug it. This not only extends the machine's lifespan but also saves on electricity costs. With the ever-evolving needs of industrial development, liquid control technology and dispensing equipment are constantly evolving towards ultra-precision control, diversification, and specialization.
Note: Clean thoroughly after each use, wiping down all visible areas with alcohol. Apply machine oil or grease to frequently moving parts to keep them lubricated. If the machine is not used for a long time, be sure to polish off the glue completely, otherwise it will solidify inside the LED dispensing machine, which will cost money to clean and is very troublesome.
